Work P5 v0.1 built

REKT-Mini

A rotary-engine compression tester for about $30 in parts.

to build
~$30
commercial testers
$200+
engines tested
4+
The REKT-Mini v0.1 board on a workbench. A green PCB carries an ATtiny85, a small OLED display and a voltage regulator, with sensor wiring leading off to the right.

The problem

A piston engine’s compression test gives one number per cylinder. A rotary engine is different. Each rotor has three faces, and each face seals its own chamber, so a single spark-plug hole sees three compression pulses for every turn of the rotor.

An ordinary gauge only holds the highest of the three. To find one weak seal you need all three, along with the cranking speed, because rotary compression figures only compare at a known RPM.

Dedicated rotary testers do this. They cost $200 or more.

What I built

REKT-Mini does the same job for about $30 in parts.

  • A custom PCB, designed in KiCad around an ATtiny85, an 8-pin microcontroller with 8 KB of flash.
  • A 0–200 PSI pressure transducer, read through the ADC.
  • A small I2C OLED that shows the result.

The firmware

  • Auto-zero. On startup the firmware averages ten readings to find the sensor’s resting offset, so it reads zero at atmospheric pressure.
  • Peak detection per face. Each chamber’s pulse is tracked with about 5 PSI of hysteresis, so sensor noise near a peak is not counted as a second pulse.
  • Cranking RPM. The time one full rotor revolution takes gives the engine speed, since the eccentric shaft turns three times for each turn of the rotor.

It has been validated on four or more engines.

J1 Connector

Open a channel

I'm always open to discussing new opportunities, interesting projects, or just talking tech.

3-pin header · message